ShellmoForums

Full Version: Replicator 1,2,2x
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Result of making 3D parts by using Replicator 1,2,2x.
I printed "coreboard" about 3 month ago.


Printer: Replicator2

Print options:
Raft:Yes
Supports:yes
I used default Profile "LOW". But, I changed speed faster.
Speed while Extruding: 150mm/s
Speed while Traveling: 200mm/s

Quality is same.
Infill: 10%
Shells: 2
Layer Hight 0.3 mm
Temperature: 230℃

Printed time:about 2hours
Result:
Printed:yes
use:difficult. Because of the shape of pin and hole.
Hole is small, and pin is fragile.
I wrote about this at here. Wink
I printed these parts about 3 month ago. I will write detail soon.
[attachment=7]
I took out Replicator2 from my home. So, I could start making Micropede by Replicator2 at here(My apartment in Tsukuba).

At first, I tryed to make "small version" of Micropede.
Please see Micropede131225a.skp or Micropede131225a.png
I'm trying to make this.

At first, I printed Micropede131225Chassis3.obj at "Low resolution".
But, It was very fragile (IMGP9149cs.jpg ).
So, I will try to redesign chasis.
I printed MP_MOTORCOVER

Print profile
Data:MP_MOTORCOVER_v002r2.obj
Printer:Replicator2
Resolution:Standard
LayerHeight:0.2mm
Raft:yes
Support:yes
Print time:12m

Result:
worked. But, I have to change the front and back of gearmotor. Please see the 2nd picture. The left motorcover is I printed. This is no problem to use, but, I will repair.

[attachment=20]
[attachment=21]
Reference URL's