ShellmoForums

Full Version: Problems
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
(04-28-2014 07:55 AM)steamboat Wrote: [ -> ]Do you have an Ultimaker at home or are you using Cura with an other RepRap printer? I never tryed out Cura.
Can you set the extrusion width in Cura or in your Makerbot Software?

I don't have Ultimaker but I using Cura for my RepRap.
Here is the screeshots of settings.
I can't set extruction width, but I can set "Flow" for modify the ammount of extruction. Normally I set this as 100%.
Pages: 1 2
Reference URL's