ShellmoForums
Problems - Printable Version

+- ShellmoForums (http://forum1.shellmo.org)
+-- Forum: Make (/forumdisplay.php?fid=1)
+--- Forum: 3D print at home (/forumdisplay.php?fid=2)
+--- Thread: Problems (/showthread.php?tid=6)

Pages: 1 2


RE: Problems - sho - 04-28-2014 08:48 PM

(04-28-2014 07:55 AM)steamboat Wrote:  Do you have an Ultimaker at home or are you using Cura with an other RepRap printer? I never tryed out Cura.
Can you set the extrusion width in Cura or in your Makerbot Software?

I don't have Ultimaker but I using Cura for my RepRap.
Here is the screeshots of settings.
I can't set extruction width, but I can set "Flow" for modify the ammount of extruction. Normally I set this as 100%.