Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replicator 1,2,2x
01-05-2014, 01:50 AM (This post was last modified: 01-05-2014 02:31 AM by sho.)
Post: #5
MP_MOTORCOVER
I printed MP_MOTORCOVER

Print profile
Data:MP_MOTORCOVER_v002r2.obj
Printer:Replicator2
Resolution:Standard
LayerHeight:0.2mm
Raft:yes
Support:yes
Print time:12m

Result:
worked. But, I have to change the front and back of gearmotor. Please see the 2nd picture. The left motorcover is I printed. This is no problem to use, but, I will repair.

   
   


Attached File(s)
.skp  MP_MOTORCOVER_v002r2.skp (Size: 36.63 KB / Downloads: 510)
.obj  MP_MOTORCOVER_v002r2.obj (Size: 29.1 KB / Downloads: 495)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Replicator 1,2,2x - sho - 12-15-2013, 01:43 AM
Coreboard - sho - 12-16-2013, 10:13 PM
RE: Replicator 1,2,2x - sho - 12-17-2013, 12:14 AM
RE: Replicator 1,2,2x - sho - 01-02-2014, 03:10 AM
MP_MOTORCOVER - sho - 01-05-2014 01:50 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)