Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Replicator 1,2,2x
12-16-2013, 10:13 PM (This post was last modified: 12-16-2013 10:15 PM by sho.)
Post: #2
Coreboard
I printed "coreboard" about 3 month ago.


Printer: Replicator2

Print options:
Raft:Yes
Supports:yes
I used default Profile "LOW". But, I changed speed faster.
Speed while Extruding: 150mm/s
Speed while Traveling: 200mm/s

Quality is same.
Infill: 10%
Shells: 2
Layer Hight 0.3 mm
Temperature: 230℃

Printed time:about 2hours
Result:
Printed:yes
use:difficult. Because of the shape of pin and hole.
Hole is small, and pin is fragile.
I wrote about this at here. Wink


Attached File(s) Thumbnail(s)
   

.obj  coreboardv001.obj (Size: 785.51 KB / Downloads: 567)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Replicator 1,2,2x - sho - 12-15-2013, 01:43 AM
Coreboard - sho - 12-16-2013 10:13 PM
RE: Replicator 1,2,2x - sho - 12-17-2013, 12:14 AM
RE: Replicator 1,2,2x - sho - 01-02-2014, 03:10 AM
MP_MOTORCOVER - sho - 01-05-2014, 01:50 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)