Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Self-introduction
04-24-2014, 08:43 AM
Post: #4
RE: Self-introduction
Tonight I milled and drilled my first SMD capable circuit board at home on the small CNC-mill. With this now I can rapid-produce my own Shellmo boards if necessary.

Circuit board held against a lamp - bores = 0.6 mm - made for SMD HC 4094 bus register driving a 6 digit LED 7 segment display.
[Image: 2014-04-23.210859-k.jpg]


Front side of the board
[Image: 2014-04-23.234119-k.jpg]


It's funny - I am going to bed now 00:34 here in Germany. Sho in Japan will have his breakfast within the next minutes and James will open the first "soft drink" after work.

Good night

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Self-introduction - sho - 04-19-2014, 03:48 AM
RE: Self-introduction - jmccartney - 04-19-2014, 06:04 AM
RE: Self-introduction - steamboat - 04-19-2014, 07:34 AM
RE: Self-introduction - jmccartney - 04-24-2014, 09:35 AM
RE: Self-introduction - steamboat - 04-24-2014 08:43 AM
RE: Self-introduction - jacklee - 04-27-2014, 08:11 PM
RE: Self-introduction - steamboat - 04-27-2014, 09:39 PM
RE: Self-introduction - xoan - 11-26-2014, 12:56 AM
RE: Self-introduction - steamboat - 11-26-2014, 01:46 AM
RE: Self-introduction - xoan - 11-26-2014, 02:18 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)