ShellmoForums / Make / Making RepWalker / Printing RepWalker Mutation RA04

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing RepWalker Mutation RA04
05-05-2014, 07:11 PM
Post: #4
steamboat Offline
Super Moderator
******
 		Posts: 262
Joined: Apr 2014
Reputation: 5
RE: Printing RepWalker Mutation RA04
Here are the base dimensions of the #1 muscle torso. I would like all of you to check if your servo dimensions fit this.

I found out that the hight of 15 mm is not enough for my servos. I will change this to 16.

Maybe I can change the 14 to 14.5 or 15 also to give the part enough strength here.

What about the snap in power switch size of 13 x 20 mm. Can you surce this in your country?

[Image: 2014-05-05.110000.jpg]
Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Printing RepWalker Mutation RA04 - steamboat - 05-05-2014 07:11 PM
First movement - steamboat - 05-06-2014, 07:03 AM
Servo - steamboat - 05-07-2014, 04:04 AM
Hip-joint back to 5 mm - steamboat - 05-10-2014, 08:18 PM
RE: Printing RepWalker Mutation RA04 - sho - 05-14-2014, 01:01 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Shellmo main page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication