Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing RepWalker Mutation RA04
05-06-2014, 12:13 AM (This post was last modified: 05-06-2014 12:16 AM by steamboat.)
Post: #8
RE: Printing RepWalker Mutation RA04
(05-05-2014 11:44 PM)jmccartney Wrote:  the nuts I am using must be a hair smaller than what Rainer designed for
This is a little tricky.. The wrench size = s (Schl├╝sselweite) of M3 is 5.5 mm and the width across corners = e (Eckma├č) is 6.01 mm (and yes, mine have e = 6.3). So we have 0.51 mm to play with. Because I hate if things don't fit - you cant rework this - I designed it with s = 6 mm. If you have a bad bridging over the nut, everything will be fine. With your super printer it will be exactly 6.01 even under the bridge and you got the result as shown...

I could reduce this to 5.5 mm but than all people with bad alligned printers will cry - so waht to do?...
   

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Printing RepWalker Mutation RA04 - steamboat - 05-06-2014 12:13 AM
First movement - steamboat - 05-06-2014, 07:03 AM
Servo - steamboat - 05-07-2014, 04:04 AM
Hip-joint back to 5 mm - steamboat - 05-10-2014, 08:18 PM
RE: Printing RepWalker Mutation RA04 - sho - 05-14-2014, 01:01 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)