Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing RepWalker Mutation RA04
05-15-2014, 11:22 AM
Post: #27
RE: Printing RepWalker Mutation RA04
Build update. Modified two hk servos like Rainer demonstrated. Very easy. Printed eye parts today, began assembly tonight.

My bolts to connect to the the eyeballs to the tie rod are too long. I only have 16mm m3 screws at the moment, so have to wait/figure out something here.

Rainer how did you fit a nut at the bottom of these anyways? They seem to not have enough clearance at the bottom?

   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
First movement - steamboat - 05-06-2014, 07:03 AM
Servo - steamboat - 05-07-2014, 04:04 AM
Hip-joint back to 5 mm - steamboat - 05-10-2014, 08:18 PM
RE: Printing RepWalker Mutation RA04 - sho - 05-14-2014, 01:01 AM
RE: Printing RepWalker Mutation RA04 - jmccartney - 05-15-2014 11:22 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)