Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Roll Pins
05-10-2014, 01:02 AM
Post: #5
RE: Roll Pins
(05-10-2014 12:49 AM)jmccartney Wrote:  I am going to make some larger sizes that should print fine on any printer.
The poit is to get it flexible enough - so the wall thickness has to be small in correspondance to the outer diameter. If the wall thickness is given by the material/printer so is the related minimum pin diameter...

What about a rectangular "shim pin" or its round counterpart the "conical pin"? Ok it'S always depends of what you want to mount/fix...

But all this should be a key discussion in the 3D printer scene!

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Roll Pins - jmccartney - 05-08-2014, 01:02 AM
RE: Roll Pins - jmccartney - 05-08-2014, 01:44 AM
RE: Roll Pins - steamboat - 05-08-2014, 07:14 AM
RE: Roll Pins - jmccartney - 05-10-2014, 12:49 AM
RE: Roll Pins - steamboat - 05-10-2014 01:02 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)