Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Possible Shield Requirements Analysis
05-12-2014, 06:04 AM (This post was last modified: 05-12-2014 06:09 AM by jmccartney.)
Post: #1
Possible Shield Requirements Analysis
This thread will be used to discuss basic requirements for a possible shellmo shield.

What do you want your shellmo to do?
--------
I think some big questions that need to be answered is:

Logic voltage?

Do we support the bio wire? Requires MOSFET integration.

Do we support motor drivers?

How much of the Arduino do you want to utilize? How much do you want to leave for future expansion, shields.

Price point per shield? A rough guestimate I did today is the PCB for the shield including lead free hasl will cost about 3.50 US a board. This is JUST the PCB. So going from their not including build labor (we assume this is free since this is our hobby Wink how much do you want to spend on a single board. Just so we can keep things sane lets just base things on 10 test units to start.

----

Help me come up with more questions at first, then we can start answering them and find the best solutions for each requirement. Then we can design.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Possible Shield Requirements Analysis - jmccartney - 05-12-2014 06:04 AM
Power Management - steamboat - 05-13-2014, 05:34 PM
Servo current - steamboat - 05-30-2014, 10:11 PM
Emoro - steamboat - 06-08-2014, 07:23 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)