Possible Shield Requirements Analysis
|
05-31-2014, 02:52 AM
Post: #31
|
|||
|
|||
RE: Possible Shield Requirements Analysis
(05-31-2014 02:22 AM)steamboat Wrote: Can't find the MAX4372T in this shop. Unless you think otherwise I am not going to worry about non-USA available SMD components as I am going to do the SMD assembly myself. If you want to give your self a go at SMD reflow I'll just send you a bunch of parts with a few extra PCBs. In this particular example I think it might just be an older part, i took look into all these we have found and then order it and do a quick test as a proof of concept. Once I have a stencil its just a matter of a lot of tweezer work and making sure your placing the components in the right spot, drop on the hot plate, and then make sure nothing shifts. Sometimes I have to run a hot iron over fine pitched legs that may have fused together. But its pretty easy, just time consuming with the tweezer ![]() |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)