Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problems
04-28-2014, 07:55 AM
Post: #10
RE: Problems
(04-26-2014 11:39 PM)sho Wrote:  the case of my RepRap with "Cura", no problem
Do you have an Ultimaker at home or are you using Cura with an other RepRap printer? I never tryed out Cura.

Can you set the extrusion width in Cura or in your Makerbot Software?

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Problems - sho - 12-16-2013, 09:22 PM
RE: Problems - sho - 12-16-2013, 09:40 PM
RE: Problems - robaktime - 12-31-2013, 11:32 PM
RE: Problems - sho - 01-02-2014, 03:14 AM
RE: Problems - steamboat - 04-19-2014, 07:55 AM
crankk pin - steamboat - 04-26-2014, 07:55 AM
RE: Problems - jmccartney - 04-26-2014, 09:31 PM
RE: Problems - sho - 04-26-2014, 11:39 PM
RE: Problems - steamboat - 04-28-2014 07:55 AM
RE: Problems - sho - 04-28-2014, 08:48 PM
RE: Problems - steamboat - 04-26-2014, 11:45 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)