Search
Member List
Calendar
Help
|
Problems
|
|
04-28-2014, 08:48 PM
Post: #11
|
|||
|
|||
RE: Problems
(04-28-2014 07:55 AM)steamboat Wrote: Do you have an Ultimaker at home or are you using Cura with an other RepRap printer? I never tryed out Cura. I don't have Ultimaker but I using Cura for my RepRap. Here is the screeshots of settings. I can't set extruction width, but I can set "Flow" for modify the ammount of extruction. Normally I set this as 100%. |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: Problems - sho - 12-16-2013, 09:40 PM
RE: Problems - robaktime - 12-31-2013, 11:32 PM
RE: Problems - sho - 01-02-2014, 03:14 AM
RE: Problems - steamboat - 04-19-2014, 07:55 AM
crankk pin - steamboat - 04-26-2014, 07:55 AM
RE: Problems - jmccartney - 04-26-2014, 09:31 PM
RE: Problems - sho - 04-26-2014, 11:39 PM
RE: Problems - steamboat - 04-28-2014, 07:55 AM
RE: Problems - sho - 04-28-2014 08:48 PM
RE: Problems - steamboat - 04-26-2014, 11:45 PM
|
User(s) browsing this thread: 1 Guest(s)