Circuits

[steamboat]

(05-11-2014 09:36 PM)jmccartney Wrote:  I do not mind making the PCB and doing the reflow work by the way and sending them to you guys

Sounds great maybe I also could learn this reflow work from you - I like input!

If we are doing a sheeld, and use servos only we even don't need any intelligent components and no reflow...

Using a atmega 32u4 would make everything smaller and maybe less power consuming. But it should stay totaly arduino compatible.

By the way I just remember this board in my shelf which I used sometimes as an AVR programmer...


Don't know how to use this because I baught this as programer only and put the given software on it with Atmel Flip like filling up your car with gas. James - can you direct me how to make it running like an Arduino?

---

Here is a link to the layout:
atmega 32_u