Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
First attempt to print RepWalker
04-19-2014, 09:03 PM
Post: #3
RE: First attempt to print RepWalker
(04-19-2014 08:26 PM)sho Wrote:  Good 3D printing quality !
Oh - no! this is quick and dirty printing...
(04-19-2014 08:26 PM)sho Wrote:  I found your mistake of attaching FrameC to FrameA.
You are right! But because I don't have a Shell for the mo, I did not realized it...

My quick and dirty servo base design is ready for printing:
[Image: 2014-04-19.11257-k.jpg]

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: First attempt to print RepWalker - sho - 04-19-2014, 08:26 PM
RE: First attempt to print RepWalker - steamboat - 04-19-2014 09:03 PM
RE: First attempt to print RepWalker - sho - 04-20-2014, 04:36 AM
RE: First attempt to print RepWalker - sho - 04-20-2014, 03:08 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 07:51 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 08:59 PM
RepWalker ra-mod-01 - steamboat - 04-22-2014, 07:16 AM
RE: First attempt to print RepWalker - sho - 04-22-2014, 05:47 PM
RepWalker Mutants - steamboat - 04-27-2014, 01:21 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 02:06 AM
Mutants - steamboat - 04-27-2014, 02:19 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 04:36 AM
Power switch - steamboat - 04-28-2014, 06:42 AM
third mutant - steamboat - 04-29-2014, 09:05 AM
Mutant got a heart - steamboat - 05-01-2014, 09:46 PM
RE: First attempt to print RepWalker - sho - 05-02-2014, 02:35 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)