Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
First attempt to print RepWalker
04-20-2014, 04:14 AM
Post: #5
RE: First attempt to print RepWalker
The acetone gluing of the ABS was successfull. I have build the drive-crank with 18 mm stroke = 9 mm crank radius. Now I found out that Sho was experimenting with 4 and 8 mm. But it's even walking with this "defect". Lots of things still to change - but Sho's concept and my mod working great:
[Image: 2014-04-19.195718-k.jpg]





Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: First attempt to print RepWalker - sho - 04-19-2014, 08:26 PM
RE: First attempt to print RepWalker - steamboat - 04-20-2014 04:14 AM
RE: First attempt to print RepWalker - sho - 04-20-2014, 04:36 AM
RE: First attempt to print RepWalker - sho - 04-20-2014, 03:08 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 07:51 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 08:59 PM
RepWalker ra-mod-01 - steamboat - 04-22-2014, 07:16 AM
RE: First attempt to print RepWalker - sho - 04-22-2014, 05:47 PM
RepWalker Mutants - steamboat - 04-27-2014, 01:21 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 02:06 AM
Mutants - steamboat - 04-27-2014, 02:19 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 04:36 AM
Power switch - steamboat - 04-28-2014, 06:42 AM
third mutant - steamboat - 04-29-2014, 09:05 AM
Mutant got a heart - steamboat - 05-01-2014, 09:46 PM
RE: First attempt to print RepWalker - sho - 05-02-2014, 02:35 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)