Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
First attempt to print RepWalker
04-22-2014, 05:47 PM (This post was last modified: 04-22-2014 05:55 PM by sho.)
Post: #18
RE: First attempt to print RepWalker
Guten Morgen,

Looks very nice !
Oh, I can see you use C clip(I called "C ring" but that's not ring, so is C clip correct ?) on Claw,too. And it's works well.

Honestly, I feel the center space (where you put Arduino and Battery) of RepWalker is waste, but the waste space must occur because, the size of "Core" and small mechanism of RepWalker.
The current Shellmo, I put Arduino UNO and Breadboard(half) on core, so core and RepWalker should be this size.

This is a problem of module stracture of Shellmo, but I feel it's no problem to occur waste space, because like your person can use the space for modifying like you did.

Any way, it's very nice !

If you can, would you please write like this at the "summary" of your movie?
Shellmo opensource robot platform
http://shellmo.org
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: First attempt to print RepWalker - sho - 04-19-2014, 08:26 PM
RE: First attempt to print RepWalker - sho - 04-20-2014, 04:36 AM
RE: First attempt to print RepWalker - sho - 04-20-2014, 03:08 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 07:51 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 08:59 PM
RepWalker ra-mod-01 - steamboat - 04-22-2014, 07:16 AM
RE: First attempt to print RepWalker - sho - 04-22-2014 05:47 PM
RepWalker Mutants - steamboat - 04-27-2014, 01:21 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 02:06 AM
Mutants - steamboat - 04-27-2014, 02:19 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 04:36 AM
Power switch - steamboat - 04-28-2014, 06:42 AM
third mutant - steamboat - 04-29-2014, 09:05 AM
Mutant got a heart - steamboat - 05-01-2014, 09:46 PM
RE: First attempt to print RepWalker - sho - 05-02-2014, 02:35 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)