Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
First attempt to print RepWalker
05-03-2014, 09:26 AM
Post: #34
RE: First attempt to print RepWalker
(05-03-2014 12:32 AM)jmccartney Wrote:  Are you going to publish this as a "remix" of the repwalker on Thingiverse?
Yes of course, I would like to let you print it - if you don't mind - and after that I will be ready with all the how to's and so on to have a good presentation on Thingiverse. And than it would be great - as you mentioned - if you would tell "the world" that you have made it...
(05-03-2014 12:32 AM)jmccartney Wrote:  As soon as you publish it will be throwing it on my printer!
Tomorrow I will start a web page under shellmo.radow.org where you can find the stl files - will tell you when it is ready.
(05-03-2014 12:32 AM)jmccartney Wrote:  Ordering servos in anticipation today!
That's great. I am interested how the dimensions will fit into my design. The question is at which positions the drive shaft is located in relation to the mounting screws. If this differs to much to the servos I have used something might not fit.

For this I should make a more variable design or at least a design without any holes to enable the end user to drill this holes as necessary.

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: First attempt to print RepWalker - sho - 04-19-2014, 08:26 PM
RE: First attempt to print RepWalker - sho - 04-20-2014, 04:36 AM
RE: First attempt to print RepWalker - sho - 04-20-2014, 03:08 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 07:51 PM
RE: First attempt to print RepWalker - sho - 04-21-2014, 08:59 PM
RepWalker ra-mod-01 - steamboat - 04-22-2014, 07:16 AM
RE: First attempt to print RepWalker - sho - 04-22-2014, 05:47 PM
RepWalker Mutants - steamboat - 04-27-2014, 01:21 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 02:06 AM
Mutants - steamboat - 04-27-2014, 02:19 AM
RE: First attempt to print RepWalker - sho - 04-27-2014, 04:36 AM
Power switch - steamboat - 04-28-2014, 06:42 AM
third mutant - steamboat - 04-29-2014, 09:05 AM
Mutant got a heart - steamboat - 05-01-2014, 09:46 PM
RE: First attempt to print RepWalker - sho - 05-02-2014, 02:35 AM
RE: First attempt to print RepWalker - steamboat - 05-03-2014 09:26 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)