Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing RepWalker Mutation RA04
05-04-2014, 10:26 PM
Post: #1
Printing RepWalker Mutation RA04
This thread is going to be used to document my printing/building Rainer's repwalker mutation for verification using the Makerbot Replicator 2. I am printing @ 0.25, 4 shells unless otherwise noted 230 degrees and 120mm/sec. I am also printing without support and raft as much as possible which looks at first glance -every stl.


Attached File(s) Thumbnail(s)
                   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Printing RepWalker Mutation RA04 - jmccartney - 05-04-2014 10:26 PM
First movement - steamboat - 05-06-2014, 07:03 AM
Servo - steamboat - 05-07-2014, 04:04 AM
Hip-joint back to 5 mm - steamboat - 05-10-2014, 08:18 PM
RE: Printing RepWalker Mutation RA04 - sho - 05-14-2014, 01:01 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)