Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing RepWalker Mutation RA04
05-05-2014, 11:44 PM (This post was last modified: 05-05-2014 11:46 PM by jmccartney.)
Post: #7
RE: Printing RepWalker Mutation RA04
Assembly update. (notice the nuts I am using must be a hair smaller than what Rainer designed for because they strip out the PLA pretty easily. You can see where they are not aligned with the nut hole.
   
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Printing RepWalker Mutation RA04 - jmccartney - 05-05-2014 11:44 PM
First movement - steamboat - 05-06-2014, 07:03 AM
Servo - steamboat - 05-07-2014, 04:04 AM
Hip-joint back to 5 mm - steamboat - 05-10-2014, 08:18 PM
RE: Printing RepWalker Mutation RA04 - sho - 05-14-2014, 01:01 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)