Printing RepWalker Mutation RA04

[steamboat]

(05-05-2014 11:44 PM)jmccartney Wrote:  the nuts I am using must be a hair smaller than what Rainer designed for

This is a little tricky.. The wrench size = s (Schlüsselweite) of M3 is 5.5 mm and the width across corners = e (Eckmaß) is 6.01 mm (and yes, mine have e = 6.3). So we have 0.51 mm to play with. Because I hate if things don't fit - you cant rework this - I designed it with s = 6 mm. If you have a bad bridging over the nut, everything will be fine. With your super printer it will be exactly 6.01 even under the bridge and you got the result as shown...

I could reduce this to 5.5 mm but than all people with bad alligned printers will cry - so waht to do?...