Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Printing RepWalker Mutation RA04
05-06-2014, 05:19 AM (This post was last modified: 05-06-2014 06:58 AM by steamboat.)
Post: #12
RE: Printing RepWalker Mutation RA04
(05-06-2014 04:26 AM)jmccartney Wrote:  The leg and its axis seem very close to being fine...
The real problem is with the tendons. They are not even close to fitting onto the axis...
Thats funny because it should have the same diameter = 5.0 mm.
As I printed it yesterday there was no need for any rework.

Yes, I will make it both 5.1 mm this will higher the chance for an easy fit right after printing.

By the way - the brain fastener is a cracker. You can not plug in the USB cable AND move the legs. A new design is on the printer already.

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Printing RepWalker Mutation RA04 - steamboat - 05-06-2014 05:19 AM
First movement - steamboat - 05-06-2014, 07:03 AM
Servo - steamboat - 05-07-2014, 04:04 AM
Hip-joint back to 5 mm - steamboat - 05-10-2014, 08:18 PM
RE: Printing RepWalker Mutation RA04 - sho - 05-14-2014, 01:01 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)