Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Roll Pins
05-08-2014, 07:14 AM
Post: #3
RE: Roll Pins
(05-08-2014 01:44 AM)jmccartney Wrote:  If I could say replace half the screws with 5mm roll pins I think that would be great.
I agree! All this need an exact counterpart in diameter. Not to big and not to small. This might be a problem?!

The M3 screw in a printed plastic hole is the first step in the right direction and is more failure tolerant. I just used M2 screws in Plastik also quite stable enough for most things - but M2 makes me nervous ;-)

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Roll Pins - jmccartney - 05-08-2014, 01:02 AM
RE: Roll Pins - jmccartney - 05-08-2014, 01:44 AM
RE: Roll Pins - steamboat - 05-08-2014 07:14 AM
RE: Roll Pins - jmccartney - 05-10-2014, 12:49 AM
RE: Roll Pins - steamboat - 05-10-2014, 01:02 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)