Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Possible Shield Requirements Analysis
05-28-2014, 06:36 PM
Post: #24
RE: Possible Shield Requirements Analysis
Good morning James,

I don't know how much such boards will cost in the US and how easy it is for you to source it in small quantity's. I could try to make it on my CNC mill but maybe the legs of the Atmel Chip are to small.

Maybe we could start with an easy board try this out and improve it step by step. Normally I am not able to make "THE GREAT THING" at the first time. And with modern rapid technologies this even is not necessary...

If prototypes are not to expansive, we can try to sell the prototypes at ebay with a printed RepWaler just for the production costs.

At the weekend - which starts in 5 hours here and will last for 4 days ;-) - I also will prepare a discussion base for the Shellmo module sizes including space for the PCB. What about batteries? Do you think we should stick with the 4x AA rechargeables?

Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Power Management - steamboat - 05-13-2014, 05:34 PM
RE: Possible Shield Requirements Analysis - steamboat - 05-28-2014 06:36 PM
Servo current - steamboat - 05-30-2014, 10:11 PM
Emoro - steamboat - 06-08-2014, 07:23 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)