Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Possible Shield Requirements Analysis
05-31-2014, 02:52 AM
Post: #31
RE: Possible Shield Requirements Analysis
(05-31-2014 02:22 AM)steamboat Wrote:  Can't find the MAX4372T in this shop.

But found a LTC6101BCS5 for 2,59
and a LTC6101AIMS8 for 3,22

In the other German "all people shop" Reichelt I also can't find any of this...

Unless you think otherwise I am not going to worry about non-USA available SMD components as I am going to do the SMD assembly myself. If you want to give your self a go at SMD reflow I'll just send you a bunch of parts with a few extra PCBs.

In this particular example I think it might just be an older part, i took look into all these we have found and then order it and do a quick test as a proof of concept.

Once I have a stencil its just a matter of a lot of tweezer work and making sure your placing the components in the right spot, drop on the hot plate, and then make sure nothing shifts. Sometimes I have to run a hot iron over fine pitched legs that may have fused together. But its pretty easy, just time consuming with the tweezer Wink
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Power Management - steamboat - 05-13-2014, 05:34 PM
Servo current - steamboat - 05-30-2014, 10:11 PM
RE: Possible Shield Requirements Analysis - jmccartney - 05-31-2014 02:52 AM
Emoro - steamboat - 06-08-2014, 07:23 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)