ShellmoForums / Make / General / Possible Shield Requirements Analysis

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Possible Shield Requirements Analysis
06-01-2014, 04:56 AM
Post: #33
steamboat Offline
Super Moderator
******
 		Posts: 262
Joined: Apr 2014
Reputation: 5
RE: Possible Shield Requirements Analysis
Here something similar

http://www.ebay.com/itm/251500805418

But for 30A so the resolution is not good.

If it is to complicated to place it on the board, we could place it into the servo itsef. There is enough space. Than we have to wire the output to any free A/D-pin...
Rainer
http://www.steamboating.de
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Power Management - steamboat - 05-13-2014, 05:34 PM
Servo current - steamboat - 05-30-2014, 10:11 PM
RE: Possible Shield Requirements Analysis - steamboat - 06-01-2014 04:56 AM
Emoro - steamboat - 06-08-2014, 07:23 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Shellmo main page | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication