Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RepSpider Alpha Build
06-24-2014, 03:02 AM
Post: #3
RE: RepSpider Alpha Build
The main change has to do with the gear/leg holder part of the chassis. I printed them in two separate pieces and removed the spacers so I could print them flat.

Doing that makes it much easier to print, but then causes a secondary problem where the two gear/leg holder parts separate at the top because they are not attached. I am just going to glue mine, but a solutions is probably needed.


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RepSpider Alpha Build - jmccartney - 06-23-2014, 04:33 AM
RE: RepSpider Alpha Build - sho - 06-23-2014, 01:07 PM
RE: RepSpider Alpha Build - jmccartney - 06-24-2014 03:02 AM
RE: RepSpider Alpha Build - jmccartney - 06-24-2014, 03:09 AM
RE: RepSpider Alpha Build - jmccartney - 06-24-2014, 10:49 PM
RE: RepSpider Alpha Build - steamboat - 06-25-2014, 08:18 PM
RE: RepSpider Alpha Build - sho - 06-26-2014, 12:10 PM
RE: RepSpider Alpha Build - jmccartney - 06-26-2014, 12:44 PM
RE: RepSpider Alpha Build - jmccartney - 06-26-2014, 12:52 PM
RE: RepSpider Alpha Build - steamboat - 06-26-2014, 04:26 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)