Post Reply 
 
Thread Rating:
  • 1 Votes - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problems
04-28-2014, 08:48 PM
Post: #11
RE: Problems
(04-28-2014 07:55 AM)steamboat Wrote:  Do you have an Ultimaker at home or are you using Cura with an other RepRap printer? I never tryed out Cura.
Can you set the extrusion width in Cura or in your Makerbot Software?

I don't have Ultimaker but I using Cura for my RepRap.
Here is the screeshots of settings.
I can't set extruction width, but I can set "Flow" for modify the ammount of extruction. Normally I set this as 100%.


Attached File(s) Thumbnail(s)
           
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)