Problems
|
04-26-2014, 11:45 PM
(This post was last modified: 04-26-2014 11:49 PM by steamboat.)
Post: #9
|
|||
|
|||
RE: Problems
I am happy to have a slicer (KISSlicer) which enables me to set layer height AND extrusion width. So I established a design standard of 0.5 in height and 0.6 in width. This makes it easy for the slicer to find a perfect fit. Because we are building small parts with thin walls it is good to have no "air" in the wall.
Therefore all my designs have wall thicknesses of a fraction of 0.6 = 0.6 - 1.2 - 1.8 - 2.4 and so on. An as mentioned above you also can print this with 0.25 mm in height and 0.3 in width... So finaly we 3 are awake at the same time ;-) Rainer http://www.steamboating.de |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
RE: Problems - sho - 12-16-2013, 09:40 PM
RE: Problems - robaktime - 12-31-2013, 11:32 PM
RE: Problems - sho - 01-02-2014, 03:14 AM
RE: Problems - steamboat - 04-19-2014, 07:55 AM
crankk pin - steamboat - 04-26-2014, 07:55 AM
RE: Problems - jmccartney - 04-26-2014, 09:31 PM
RE: Problems - sho - 04-26-2014, 11:39 PM
RE: Problems - steamboat - 04-28-2014, 07:55 AM
RE: Problems - sho - 04-28-2014, 08:48 PM
RE: Problems - steamboat - 04-26-2014 11:45 PM
|
User(s) browsing this thread: 1 Guest(s)